Waveshare XCore407I, STM32F4 Core Board

Overview & Features

Overview. XCore407I is an STM32 MCU core board that features the STM32F407IGT6 on board. Clock circuit, USB power management. Onboard devices: USB HS PHY, Ethernet PHY, 1G Bit NandFlash. Connectors：USB HS (mini / type A), USB FS (mini), Ethernet (RJ45). All the idle I/O ports are accessible on the pin headers. 2.0mm pin header pitch, smaller size, easier to integrate into user system. Note: please consider the EVK407I, which supports easily programing/debugging.. What is On Board. STM32F407IGT6 development board on board resource.. STM32F407IGT6: The high performance STM32 MCU which features:. - Core: Cortex-M4 32-bit RISC. - Feature: a full set of single-cycle DSP instructions. - Operating Frequency: 168MHz, 210 DMIPS/1.25 DMIPS/MHz. - Operating Voltage: 1.8V-3.6V. - Package: LQFP176. - Memories: 1024kB Flash, 192+4kB SRAM. - MCU communication Interfaces:. -- 3 x SPI, 4 x USART, 2 x UART, 2 x I2S, 3 x I2C. -- 1 x FSMC, 1 x SDIO, 2 x CAN. -- 1 x USB 2.0 high-speed/full-speed device/host/OTG controller with dedicated DMA, ULPI and on-chip full-speed PHY. -- 1 x 10/100 Ethernet MAC. -- 1 x 8 to 14-bit parallel camera interface. - AD & DA converters: 3 x AD (12-bit, 1μs, shares 24 channels); 2 x DA (12-bit). - Debugging/Programming: supports JTAG/SWD (serial wire debug) interfaces, supports IAP. MIC2075-2, onboard USB FS power management device. AMS1117-3.3, 3.3V voltage regulator. K9F1G08U0E, 1G Bit NandFlash. DP83848, Ethernet PHY. MIC2075-1, onboard USB HS power management device. USB3300, USB HS PHY. Power supply switch, powered from 5Vin or USB connection. Boot mode switch, for configuring BOOT0 pin. Power indicator. USB FS LED. USB HS LED. Reset button. 8M crystal, MCU clock, enables the MCU run at higher speed by frequency multiplication. 24M crystal, USB3300 clock. 50M crystal, DP83848 clock. 32.768K crystal, for internal RTC with calibration. Ethernet connector. USB FS mini connector. USB HS mini connector. USB HS type A connector. MCU pins expander, VCC, GND and all the idle I/O ports are accessible on expansion connectors for further expansion. USB OTG/HOST jumper. VREF/VBAT jumper. Ethernet I/O selection solder joint. USB HS I/O selection solder joint. PDR selection solder joint: 1.8-3.6V, -40～105℃ OR 1.7-3.6V, 0～70℃.. Package Contents. XCore407I development board x 1. USB type A to Mini-B cable x 1. Software CD x 1..

Technical Specifications